Varec 2920 Installation And Operation Manual page 74

2920 Float & Tape Transmitter
64
To Access Encoder Data:
1. Press Enter to access the Main Menu. The System Menu point is automatically highlighted.
Main Menu 04
Encoder Data
RTD Data
Tank Data
2. Press Minus four times to move the highlight to Encoder Data.
3. Press Enter and the Encoder Data menu opens as shown below.
4. To select one of the options, press Minus to move the highlight to the option you want and
then press Enter.
Refer to the table below for more information on each Encoder Data option.
Display Only
Level
Field Voltage
Internal Temp.
Number Resets
FDisk
IDisk
Enc State
Feet
Inches
Sixteenths
Encoder Data
Display Only
Config Params
All Params
Description
This parameter represents the level in feet derived from
the absolute encoding process. This parameter is always
encoded in the forward rotation direction.
The value of the DC Voltage (Field Voltage) applied to
the transmitter to power the unit.
The temperature in degrees Fahrenheit of the internal
electronics.
Shows the number of types the transmitter has reset -
soft or power resets. This value resets to zero when a
hard reset is performed.
This parameter is a 12-bit value indicating the level read
from the foot encoder sensor.
This parameter is a 16-bit value indicating the level read
from the fractional foot (inches) encoder sensor.
This is a diagnostic code that describes the encoder
state.
This parameter indicates the feet portion of the level
derived from the absolute encoding process. This
parameter is shown in foot units from zero to ninety-
nine in binary.
This parameter indicates the inches portion of the level
derived from the absolute encoding process. This
parameter is shown in inch units from zero to eleven in
binary.
This parameter indicates the 1/16-inch portion of the
level derived from the absolute encoding process. This
parameter is shown in 1/16-inch units.
5 Display and Configuration Interface
Installation and Operations Manual