Varec 2920 Installation And Operation Manual page 106

2920 Float & Tape Transmitter
96
Cmd Status
Cmd Error
Comm Tries
Comm. Fails
Pnt Status
Elapse
Pnt CheckSum
Command
Command
Scan Cmd
Config Params
Addr
Manuf ID
Device Type
Device ID
Preambles Cmd
Frame Format
Tank Shape
Medium Prop.
Process Prop.
Empty Calibra.
The status of command, as follows:
• Start
• Complete
• Error
The number of error if Command fails.
The number of times the 2920 has polled the FMR.
The number of time the communications from the 2920
to the FMR has failed.
Byte value indicating status of point. Values are:
0: No error
Time of last update.
CRC-16 Checksum of point's static configuration
parameters.
This parameter sends send various commands directly
to the FMR. This is for development purposes, and
should not normally be adjusted by the user.
This parameter reads certain data directly from the
FMR. This is for development purposes, and should not
normally be adjusted by the user.
The short HART address used to detect this device.
The Unique ID of the Manufacturer that build the HART
device. For FMR, this is 17 - E+H.
The unique device type specified by the HART device
manufacturer. For FMR, 0 to 49
The long HART ID number read from the HART device,
containing manufacturer, device type and ID number.
The number of Preambles: The minimum number of
pre-ambles the FMR device is requesting for
communication.
Type of message framing supported by the FMR.
This is a selectable parameter to choose the tank shape.
This is a selectable parameter to choose the dielectric
constant of the product.
This is a selectable parameter in which the process
conditions are described. The FMR53x will work with
"mm accuracy" if the options "standard" or "calm
surface" are selected.
Distance from sensor flange to minimum level of the
tank.The value is displayed in distance unit (m/ft/inch/
mm).The Empty calibration is used to calculate the level
value.
5 Display and Configuration Interface
Installation and Operations Manual