Varec 2920 Installation And Operation Manual page 70

2920 Float & Tape Transmitter
60
Cal Level
Control
Parity
MODBUS Reg MAP
Temp Offset Mode
Temp Disp Units
Data Mode
Speed Mode
Calibration Level is used to set (calibrate) the encoder
level.
Note If you enter a decimal value, the 2920 interprets
the measurement as a decimal value and applies the
Level Display Units to format the level. If you enter a
string of numbers separated by a dash (xx - xx - xx), the
2920 applies the format of feet-inches-sixteenths.
This parameter is used to enable the +24VDC power
bus. This bus can be used for Active HART, 4-20 input
and 4-20 outputs. The Bus can provide ~50 mA of
current.
Communications Parity. Selections are:
None
Even
Odd
Note This parameter is for MODBUS devices only.
Selections are:
2920 Map
GSI Map
Note This parameter is for MODBUS devices only.
°
Applies 100 temperature offset to detected value.
Selections are:
No offset
°
Offset Temp 100
Note This parameter is for Mark/Space devices only.
Indicates the display units of Temperature. Selections
are:
°
F
°
C
Pulse code format of the Mark/Space message.
Selections are:
Fractional + Temp
Decimal + Temp
20 meters + Temp
30 meters + Temp
Fract. No Temp
Decimal No Temp
20 meters No Temp
30 meters No Temp
Note This parameter is for Mark/Space devices only.
Indicates timing of the message. Selections are:
High
Low
Note This parameter is for Mark/Space devices only.
5 Display and Configuration Interface
Installation and Operations Manual