Varec 2920 Installation And Operation Manual page 65

Varec, Inc.
To Access the System Data:
1. Press Enter to access the Main Menu. The System Data point is automatically highlighted.
Main Menu 00
System Data
Basic Setup
Local RS-232
2. Press Enter to open the System Data parameters and the System Data options appear.
3. To select one of the options, press Minus to move the highlight to the option you want and
then press Enter.
4. Refer to the table below for more information on each System Menu option.
Display Only
Software Version
Hardware Version
Field Protocol
Number DB Pnts
DB Size
Build Date
Sys Checksum
Pnt Checksum
Commands
Admin PIN
User PIN
Display Test
Reset Cmd
System Data
Display Only
Commands
Config Params
All Params
Description
The firmware version.
The PCB hardware version.
Specifies the type of the interface hardware available
for the primary interface, such as Bi-Phase Mark,
MODBUS, Mark/Space, and so on.
The number of database points defined.
The size of the database in bytes.
The date the database structure was generated.
CRC-16 Checksum of the firmware.
CRC-16 Checksum of point's static configuration
parameters.
Description
Allows you to set the administrative PIN code. See
"Administrative PIN".
Allows you to set the user PIN code. See "User PIN".
The Display test temporarily illuminates all segments of
the graphical display to test the operation of the display.
The Reset Command allows reset of the transmitter
through the user interface. A soft reset restarts the
application. A hard reset resets all configuration data to
default values.
Note Be careful not to perform a hard reset inadver-
tently.
5 Display and Configuration Interface
55