Varec 2920 Installation And Operation Manual page 122

2920 Float & Tape Transmitter
112
7. Press Enter to modify the Unit Addr parameter.
8. Press Minus or Plus to move to the appropriate number for this device.
Note To backspace, press Minus to access the back arrow (
9. If the Unit Addr requires a two-digit number, press Enter to move to the next digit.
10. Select the second digit using Minus or Plus.
11. Press Enter to select the Return arrow (
12. Press Cancel to exit each menu and return to the Home display.
To Set the 2920 FTT Speed Mode
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Speed Mode.
3. Press Enter to modify the Speed Mode parameter.
4. Press Minus or Plus to select either High or Low for this device.
5. Continue following steps 9 through 12 above to complete the Speed Mode setup.
To Set the 2920 FTT Encoder Type
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Encoder Type setting.
3. Press Enter to modify the Encoder Type parameter.
4. Press Minus or Plus to move to the appropriate Encoder Type setting for this device.
5. Continue following steps 9 through 12 above to complete the Encoder Type setup.
To Set the 2920 FTT Data Format
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Data Mode setting.
3. Press Enter to modify the Data Mode parameter.
4. Press Minus or Plus to move to the appropriate Data Mode setting for this device.
5. Continue following steps 9 through 12 above to complete the Data Mode setup.
To Set the 2920 FTT Temp Offset Mode
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Temp Offset Mode.
3. Press Enter to modify the Temp Offset Mode parameter.
4. Press Minus or Plus to move to the appropriate Temp Offset Mode Setting for this device.
5. Continue following steps 9 through 12 above to complete the Temp Offset Mode setup.

). Press Enter to backspace.

) and save the Unit Addr.
Installation and Operations Manual
8 Mark/Space