Varec 2920 Installation And Operation Manual page 135

Varec, Inc.
1. Remove the 2920 FTT cover.
2. Connect a laptop computer running ViewRTU software to the RS-232 connector (J6) on the
communications circuit board. The following figure shows the connector.
LED D4
J6
RS-232
J6
J12
Note Input and output terminals are identified in a table on page 35.
Start the ViewRTU application. The user is prompted to select a firmware version file as shown
in the following figure.
3. Select the file that matches the communications protocol used by the 2920 FTT, and then
click OK. The main screen appears, as shown in the following figure.
SW1
RESET
SW2
LED
J8
J12
11 Configuration & Calibration — Level, Limits, and Outputs
SW1
Reset SW2
J8
J9
J7
J7
J9
SW6
SW6
J11
J11
125