Returning The 2920 Ftt To Factory Default Settings - Varec 2920 Installation And Operation Manual

2920 Float & Tape Transmitter
134
5. Using the icons or the Point menu, select a point. The dialog box for that point appears.
6. View or edit the information as needed. Refer to "Display and Configuration Interface" for
information about each database point.
7. Repeat steps 5 and 6 as needed for other points.
8. Close ViewRTU.
9. Disconnect the laptop computer cable from the RS-232 connector.
10. Replace the 2920 FTT cover.

Returning the 2920 FTT to Factory Default Settings

Note This procedure resets all level and temperature alarm setpoints.
The 2920 FTT can be reset to factory default setting in using either of the procedures below:
This procedure initializes all 2920 FTT configuration parameters to factory default settings,
using the display interface.
12 Maintenance and Troubleshooting
Installation and Operations Manual