Advertisement
Step 9
(Cable Mount & Truss Assembly)
st
In Step 9 the lower cable mount brackets will be installed. On the 1
tube bolt cable mount brackets (30976) to
the left & right side of the hopper arm bracket as shown. These will be fastened using (2) 5/8" x 1-1/2" flange
bolts & nuts. Be sure to angle the cable mount bracket slightly upwards as shown in figure 9.1.
Fig. 9.1
Step 10
nd
rd
Next the cable truss uprights and cross brackets will be assembled on the 2
& 3
tubes. Start by placing the 2
upright truss brackets (10163) on the tube and fastening with a total of (12) 3/8" x 1" carriage bolts & flange
nuts. Leave these a little loose for ease of assembling the cross member. Assemble the cross member (10174)
using a total of (6) 3/8" x 1" carriage bolts & flange nuts as shown. After all carriage bolts are tigtenen, place
the 3/8" cable clamps on the out side of the trusses as shown. Thread nuts on by hand but do not tighten. If
assembling an H1082 cable clamps will also have to be added on the inside holes on the upper and middle
trusses.
Fig. 10.1
Fig. 10.2
Harvest by Meridian H10XX Assembly Manual
Page 7 of 34
Advertisement
