Advertisement
Step 26
Locate the 41 foot cables. Attach cable to eyebolts on the left & right side cable truss mount brackets. Attach
using the same process specified in step 25. Pull cable past the first truss keeping the cable on the outside of
nd
rd
the truss. Put the cable through the outer cable clamps located on the 2
& 3
truss. When the cable is through
rd
both cable clamps, continue pulling the cable to the quicklink located on the joint on the end of the 3
tube.
Secure using (2) 3/8" cable clamps as shown if fig. 26.3. Repeat on opposite side of the auger. On an H1062
this will be the discharge head joint.
If
assembling an H1062 & H1072 skip Step 27 and Step 28. Go to Step
29.
Fig. 26.1
Fig. 26.2
Fig. 26.3
Harvest by Meridian H10XX Assembly Manual
Page 17 of 34
Advertisement
