Advertisement
Step 27
(H1082 Only)
Locate the 41 foot cables. Attach cable to eyebolts on the top cable truss mount brackets. Attach using the
same process specified in step 25. Pull cable past the first truss running them on the inside of the truss. Put the
cable through the inner cable clamps located on the 2
clamps, continue pulling the cable to the quicklink located on the joint on the end of the 3
(2) 3/8" cable clamps as shown if fig. 26.3. Repeat on opposite side of the auger.
Fig. 27.1
Step 28
(H1082 Only)
Locate the 61 foot cables. Attach cable to eyebolts on the left & right side cable truss mount brackets (Fig.
27.1). Attach using the same process specified in step 25. Pull cable past the first truss keeping the cable on
the outside of the truss. Put the cable through the outer cable clamps located on the 2
cable is through both cable clamps, continue pulling the cable to the quicklink located on the joint on the end of
rd
the 4
tube. Secure using (2) 3/8" cable clamps as shown if fig. 28.2. Repeat on opposite side of the auger.
Fig. 28.1
Harvest by Meridian H10XX Assembly Manual
nd
rd
& 3
truss. When the cable is through both cable
rd
tube. Secure using
Fig. 27.2
nd
rd
& 3
truss. When the
Fig. 28.2
Page 18 of 34
Advertisement
