Advertisement
Step 14
Next, insert (2) 1/4" x 1" square keys into the top & bottom shaft. Slide the 18 tooth sprocket onto the top shaft
& the 20 tooth sprocket onto the bottom shaft as shown in fig. 14.1. Use a measuring tape & measure the
distance from the center of each sprocket to the infeed housing. Once sprockets are aligned, apply lock-tite to
set screws & tighten.
Step 15
Locate the #60 chain, #60 half link, & #60 connector link. Attach the half link to the chain on one end & place
the chain around the sprockets as shown in fig. 15.1. Secure chain with connector link. When connector link is
installed & the loop has been completed, push the idler sprocket in the chain to achieve good tension. When
proper tension is achieved tighten the idler sprocket. Now grease top & bottom bearings with multi-lith grease.
Harvest by Meridian H10XX Assembly Manual
Fig. 14.1
Fig. 15.1
Page 10 of 34
Advertisement
