Advertisement
Step 20
Next the hopper winch will be mounted. On the right side of the infeed housing there is a bracket with a pin
through it. (Fig. 20.1) Remove pine & set aside. Remove bracket & attach to winch using (3) 3/8" x 1"
carriage bolts & flange nuts as shown in fig. 20.2. Tighten bolts by hand only for now. Slide the winch handle
onto winch with spring & nut. Tighten nut to secure handle. Place winch on top of bracket welded to the infeed
housing and secure with the pin. Angle the winch so it is centered with the top bracket (hopper arm bracket) on
st
the 1
tube as shown in figure 20.3. Tighten the (3) 3/8" x 1" carriage bolts.
Fig. 20.1
Fig. 20.2
Fig. 20.3
Harvest Iby Meridian H10XX Assembly Manual
Page 13 of 34
Advertisement
