Advertisement
Step 46
Using a lifting strap, lift the scissor hinge part of the carriage up toe the auger tube. Lift carriage up within
approximently 1/4" of the auger tubes. Be sure to keep the discharge end the auger supported at this time. Lift
both carriage arms up and attach to the lower carriage mount bracket using (2) 1" x 2" grd. 8 hex bolt & lock
nut. Tighten bolts allowing a little "play" in the bolt. Next move to the carriage arm spacer plate & tighten the
(4) 3/8" x 1" flange bolts & flange nuts.
Fig. 46.1
Step 47
Route the hydraulic hose attached to the tube up and around the upper scissors and back through the carriage
mount bracket on the tube. (Fig. 47.1) Mount the hydraulic hose to the inner part of the upper scissors using
(2) 1/2" hose "P" clamps & 1/4" flange nuts as shown in fig. 43.2.
Fig. 47.1
Harvest by Meridian H10XX Assembly Manual
Fig. 46.2
Fig. 47.2
Page 29 of 34
Advertisement
