Table of Contents
Advertisement
6. Select the parameter with the arrow keys, or type in a value.
7. Press the Left arrow to save your choice.
Use the descriptions in
configure the options in the Offroute dialog box.
TIP
When you are finished setting up the parameters, you can collect the
Offroute measurement.
See
Collect Orbit Measurements on page 178
Table 1 - Offroute Orbit Parameters
Parameter
Units
Transducer
Sensitivity
Trigger
Ext Trig Slope
Level
Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Offroute Orbit Parameters on page 177
The Units, Transducer, Filter, and Sensitivity apply to
both channels. The two input channels are X and Y.
Description
Sets the measurement units for the
transducer.
The transducer used to collect this
measurement.
The sensitivity of the transducer.
The sensitivity value is included with the
transducer's documentation or it may be
imprinted on the side of the transducer.
Determines whether the trigger is on or off.
When Trigger is set to Off the rpm value must
be entered during data collection.
The input signal slope to be used for externally
triggering the measurement
+ve
Defines the trigger event to occur on a rising
edge.
-ve
Defines the trigger event to occur on a falling
edge.
The amplitude level for externally triggering
the measurement.
The level is a percentage of the trigger full
scale range.
Multi-channel Measurements
to help you
for more information.
Values/Comments
Disp (mil)
Disp (µm)
Prox Probe
Accel
200 mV/EU (default)
On
Off
+ve
-ve
2.0 (default)
Chapter 6
177
Advertisement
Table of Contents
