Table of Contents
Advertisement
8. Choose Edit > Copy to copy the location.
9. Move to an empty row in the Location pane and choose Edit > Paste to
paste the location into the spreadsheet.
10. Edit the new location to change the Direction and set Lo. Channel to 1Y.
11. Repeat steps
pane.
12. Edit the new location to change the Direction and set Lo. Channel to 1Z.
TIP
13. Now include these measurement definitions in a list.
You can create a new list or recall the current list. The locations must be
tagged to create a group list.
14. Add the three locations to a group list by double-clicking the Group
column in the Location pane.
The current group number appears in the Group column. Make sure you
assign the locations to the same group number. The group is then loaded
with the list to the Dynamix 2500 data collector.
This figure shows the typical measurement location setup for tri-axial
measurements.
Figure 22 - Tri-axial measurement location setup
Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
7
and
8
to copy and paste the third location into the Location
The Location ID and Position must be the same for all three tri-
axial measurements.
Setting Up Measurements
Chapter 3
103
Advertisement
Table of Contents
