Table of Contents
Advertisement
Storing Unscheduled Data
Collect a User-defined Measurement
Follow these steps to collect a user-defined measurement.
1. After setting up the measurement, connect the proper transducer.
2. Press Enter from the Offroute User screen to start the measurement.
The measurement screen appears. The Dynamix 2500 data collector
ranges and collects the data.
3. If desired, press F3 (Notes) to assign inspection codes to each point.
The Dynamix 2500 data collector unloads the inspection codes when you
unload the unscheduled data to Emonitor.
See
Select Inspection Codes on page
4. If you want to collect data again for this point, press F2 (Retake) to collect
the measurement again.
5. Once the Dynamix 2500 data collector collects the measurement, press
Enter to accept the measurement.
The green status indicator illuminates when the measurement is complete.
The measurement is stored as an Offroute measurement at the current
point.
The Offroute screen reappears.
6. Press F4 (Esc) screen to return to the Data Collection screen.
When you unload unscheduled measurements from the Dynamix 2500 data
collector, The Emonitor software stores it in the database. There are two
methods for storing.
Follow these steps to use the Smart Unscheduled mode.
1. Select Tools > Load/Unload.
2. Click Unload Options.
3. Check the Unscheduled location smart mode checkbox.
Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Collecting and Reviewing Data Chapter 5
137.
159
Advertisement
Table of Contents
