Table of Contents
Advertisement
Set Up Communication
Loading and Unloading
The Dynamix 2500 data collector communicates with the Emonitor software to
load and unload routes/lists.
Topic
Set Up Communication
Loading Lists to the Data Collector
Unloading Lists from the Data Collector
IMPORTANT
There are many steps required to set up communication both in the Emonitor
software and in your data collector. The steps include the following:
• Selecting the computer communication options in the Emonitor software.
• Selecting the Dynamix 2500 data collector as the current data collector.
• Setting up the data collector to communicate with the computer.
• Installing ActiveSync software to communicate through a USB port.
• Connecting the data collector and the computer.
Most of the steps are completed from the Load/Unload dialog box. Click Set Up
Collector and Set Up Computer to set up the Dynamix 2500 data collector and
computer for communication.
Use the USB Connection
You use the USB port to load lists from The Emonitor software and unload data
from the Dynamix 2500 data collector. This interface requires you to install
Microsoft ActiveSync software:
• See
POWER /USB/TRIGGER on page 20
cable.
• See
Installing the USB Drivers for the Data Collector on page
Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
For more information about loading lists and the Load/Unload dialog
box, refer to the Emonitor software online help.
Chapter
Page
107
113
121
for information on the splitter
30.
4
107
Advertisement
Table of Contents
