Assembly; Mounting Position; Handwheel Fitting; Multi-Turn Actuator: Mount To Valve/Gearbox - AUMA SAEx 07.2 Operation Instructions Manual

SAEx 07.2 SAEx 16.2 / SAREx 07.2
ACExC 01.2 Intrusive HART
4.

Assembly

4.1.

Mounting position

4.2.

Handwheel fitting

Information
4.3.

Multi-turn actuator: mount to valve/gearbox

4.3.1. Output drive types B, B1
Application
Design
SAREx 16.2 Control unit - electromechanical
AUMA actuators and actuator controls can be operated without restriction in any
mounting position.
For transport purposes, handwheels from a diameter of 400 mm are supplied separ-
ately.
Figure 5: Handwheel
[1] Spacer
[2] Input shaft
[3] Handwheel
[4] Circlip
1. If required, fit spacer [1] onto input shaft [2].
2. Slip handwheel [3] onto input shaft.
3. Secure handwheel [3] using the circlip [4] supplied.
Danger of corrosion due to damage to paint finish and condensation!
Touch up damage to paint finish after work on the device.
After mounting, connect the device immediately to electrical mains to ensure
that heater minimises condensation.
B4 and E
For rotating, non-rising valve stem
Not capable of withstanding thrust
Output drive bore with keyway:
Types B1 B4 with bore according to EN ISO 5210
Types B and E with bore according to DIN 3210
Later change from B1 to B3, B4, or E is possible.
Assembly
13