Advertisement
P/N 3124450_A
15
INSTALLING BUMPERS
Offsetting the bumpers and top rails helps to disguise the joint locations, giving the lineup a smoother look.
Begin at the left end of the line-up. A starter bumper is factory-installed with end kits. Insert the internal joint
trim, then add the full-length bumper.
Align each bumper section with its retainer and push into place, working from the end of the lineup. Install full
length bumpers and internal joint trims offset across joints. Make sure that no gaps exist between sections.
Continue installing bumpers the length of the line up.
Do NOT install the last bumper sections at this time. These sections will be installed in the last step. Once all
except the last section of bumper have been installed, refrigerate the case line-up for at least six (6) hours. The
last sections of bumper should be kept inside a refrigerated case or cooler during this time to allow the bumpers
to contract.
Before installing the last full-length section, measure the remaining space. Use a miter box and fine-tooth saw
to cut last bumper to length. Install the last section. Remove protective film from bumpers once installation is
complete. Optional end bumpers are factory-installed.
Freedom Reach-in
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Advertisement
