Table of Contents
Advertisement
1-6
R
I
1-6
efRigeRation
NSTALLATION
Seal Merchandisers
1. Apply butyl tape across the bottom joint.
Be sure to extend the tape up the back and
front of the case.
Butyl Tape
2. Use field-supplied silicone to fill any gaps
between the front support brackets.
Front
Detail
SPLASHGUARD BRACKET
AND JOINT SUPPORT
Install Splashguard Bracket
Position splashguard brackets to the merchan-
diser and level to the floor. Each bracket has a
1
/
in. (38 mm) slot at the rear of the bracket
1
2
where it attaches to the merchandiser. Tighten
screws to secure the brackets.
Bracket
P/N 0518258_C
P/N 0518258_D
/ e
lectRical
Silicone
Field Supplied
Base of Case
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Install Splashguard Joint Support
Position the joint support across the brackets
as shown above. Fasten with hex head sheet
metal screws.
Screw
OFFSETTING BUMPERS AND TOP RAIL
Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
1. Locate starter bumpers and top rail. They
are shipped with the left-end kit.
2. Remove factory installed top rails and
bumpers from cases as follows:
Joint Support
Advertisement
Table of Contents
