Installing Bumpers - Hussmann REACH-IN Installation & Operation Manual

INSTALLING BUMPERS

Offsetting the bumpers and top rails helps to disguise the joint
locations, giving the lineup a smoother look.
Begin at the left end of the line-up. A starter bumper is factory-installed
with end kits. Insert the internal joint trim, then add the full-length
bumper.
Merchandiser
Joint
Internal Joint
Trims
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3053328_H
Merchandiser Joint
Full Length
Bumpers
Starter
Bumper
Align each bumper section with its retainer and push into place,
working from the end of the lineup. Install full length bumpers and
internal joint trims offset across joints. Make sure that no gaps exist
between sections. Continue installing bumpers the length of the line up.
Do NOT install the last bumper sections at this time. These sections will
be installed in the last step.
Once all except the last section of bumper have been installed,
refrigerate the case line-up for at least six (6) hours. The last sections
of bumper should be kept inside a refrigerated case or cooler during
this time to allow the bumpers to contract.
Before installing the last full-length section, measure the remaining
space. Use a miter box and fine-tooth saw to cut last bumper to length.
Install the last section. Remove protective film from bumpers once
installation is complete. Optional end bumpers are factory-installed
Bumper End Caps can be adjusted
horizontally to eliminate gaps.
1-11
Bumper
Miter Box