Configuring The Bacnet/Ip Connection - ABB FBIP-21 BACnet/IP User Manual

28 Start-up

Configuring the BACnet/IP connection

WARNING! Obey the safety instructions given in this
manual and the drive documentation.
After the adapter module has been mechanically and electrically
installed according to the instructions in chapters
installation and Electrical
for communication with the module.
The detailed procedure for activating the module for BACnet/IP
communication with the drive depends on the drive type. Normally,
you must adjust a parameter to activate the communication. See
the drive-specific start-up sections starting on page 36.
Once communication between the drive and the adapter module
has been established, several configuration parameters are copied
to the adapter module. These parameters are shown in the tables
below and must be checked first and adjusted where necessary.
You can adjust the parameters via a drive control panel or a PC
tool.
Note: The new parameter settings take effect only when you power
up the module the next time or when you activate the fieldbus
adapter refresh parameter.
installation, you must prepare the drive
Mechanical