Festo IFB05-03 Manual page 42

3. Installation
1
Green LED
2
Red LED
3
Plug for field bus
cable
4
Fuse for the oper
ating voltage of
the inputs
5
Operating voltage
connection
Fig. 3/1: Cover of the node
3−8
The following connecting and display elements can be found
on the cover of the node:
5
Please note
The cover is connected to the internal printed circuit
boards by means of the cables for the power supply and
cannot therefore be removed completely.
Opening
Unscrew and remove the 6 Philips screws in the cover. Care
fully lift up the cover. Do not damage the cable as a result of
mechanical stress.
Closing
Replace the cover. Push the cables for the operating voltage
connection back into the housing, so that the cables are not
squashed. Tighten the Philips screws of the cover in diag
onally opposite sequence.
BUS
Festo P.BE−VIFB5−03−EN en 0503e
1
2
3
4