Festo IFB05-03 Manual page 81

4. Commissioning
Program extract
IF
AND
THEN SET
SET
SET
0)
Fig. 4/8: Example Addressing the inputs/outputs
Festo P.BE−VIFB5−03−EN en 0503e
Example
Configuration
FPC405 system with:
processor system address E.CFA: 4
Field bus address of the valve terminal 16
With mixed fittings as shown in the diagram below, outputs 1,
11 and 20 are to be set and inputs 0, 10 are to be loaded.
Valve no.
E416.0.0 "input 0
E416.1.2 "input 10
A416.0.1 "output 1
A416.1.3 "output 11
A416.2.4 "output 10
Further details on addressing and programming can be found
in the PLC manual for your controller (e.g. Festo system man
ual FPC 405, chapter 7).
0 1 2 3 4
(1st. input module, input 0)
(2nd. input module, input 2)
(valve 1, upper coil)
(valve 6, lower coil)
(2nd. output module, output
5 6
4−19