Festo IFB05-03 Manual page 32

2. Fitting
1
Hat−rail clamping
unit unlocked
2
Hat−rail clamping
unit locked
3
Locking screw
Fig. 2/3: Fitting the type 03 valve terminal to a hat rail
2−8
Proceed as follows:
1. Ascertain the weight of your valve terminal as described
in chapter 2.3
2. Make sure that the mounting surface can support this
weight.
3. Fit a hat rail (support rail as per EN 50022 − 35x15;
width 35 mm, height 15 mm).
4. Fasten the hat rail to the fastening surface at least every
100 mm.
5. Hang the valve terminal onto the hat rail. Fasten the valve
terminal on both sides with the hat−rail clamping unit to
prevent it from tilting or sliding (see Fig. 2/3).
6. If the hat−rail clamping unit is subject to vibration or if it is
fitted in a sloping position, fasten it with two locking
screws (item 3) against unintentional loosening/opening.
1 2 3 3
Festo P.BE−VIFB5−03−EN en 0503e