Handling And Operation; Switching The Appliance On/Off; Air Outlet Valve - Silvercrest SLE 280 A2 Operating Instructions Manual

Handling and operation

In this section, you will receive important information pertaining to appliance
handling and operation.
Switching the appliance on/off
♦ Press the STAND-BY button
LED
♦ Press the STAND-BY button
LED
NOTE
► The appliance starts in the mode last selected.
► After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating guard, the appliance starts in
the mode last selected.
♦ If a timer has been programmed, the appliance switches off definitively
upon lapse of the time specified (1-24 hour/s).
♦ If the relative humidity value has been defined in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦ The appliance switches off if the water tank
If wrongly positioned, or if the water tank
FULL LED
switched on.
NOTE
► The water tank
condensate cannot be collected properly.

Air outlet valve

Always open the air outlet valve
gramme. If the valve
ance off after some time for approx. 3 minutes.
SLE 280 A2
lights up.
20
goes out.
20
flashes and an audible signal is emitted if the appliance is
19
5 must be fully inserted in the appliance; otherwise, the
is not opened, the overheating guard switches the appli-
to switch the appliance on. The OPERATION
21
to switch the appliance off. The OPERATION
21
5 is full or has been removed.
has been removed, the TANK
5
, regardless of the appliance's respective pro-
GB │ MT │ 37 ■