Operating Information - Mendota ML39 Assembly, Installation And Operating Instructions

5.4 OPERATING INFORMATION

Using Your Remote Control
Your Mendota remote control is pre-programmed to your fireplace. Ensure you have installed 3 AAA batteries into your remote.
Press the top button on the remote control. If you do not hear a beep when you press this button, follow the instructions below
to synchronize your fireplace and remote control.
Synchronizing the Fireplace and Remote Control
Master Switch " The master switch acts as the main safety on/off control for the main gas burners only.
When the master switch is in the off-condition, the main gas burners will not turn on. However, all other
fireplace functions, including the standing pilot mode, will operate. When the master switch is in the on -
condition, the main burners will function as designed.
In case of an emergency, toggle the master switch to off to turn off the main burners.
To synchronize the fireplace and remote control, follow the steps below:
Toggle the master switch to "ON". Switch is in the ON position when pointing to the left, as shown in the diagram below.
1.
Locate sync switch (see diagram below). Press the sync button and release. The fireplace will beep three times indicating
2.
that it is ready to synchronize with a remote control. (Note: If you do not hear any beeps when you press the sync button,
contact your Mendota dealer or installer for assistance.)
Within seven seconds, press the "on" button on the remote control. The fireplace will beep four times to indicate that the
3.
remote control's command is accepted and sets to the particular code of that controller. Your system is now initialized.
85-03-01136 ML39 Page 68