PF2 Ignition System Diagram
Note: Connect wires in junction box located on the right
side of this appliance to house power using supplied wire
nuts.
Note: On Décor models, the Split Flow circuit is
not installed nor used.
Replacement wires must have the same type and size of
insulation as the original.
85-03-01136
This appliance must be electrically connected and grounded
in accordance with local codes or, in the absence of local
codes, with the current NFPA 70- National Electric Code or
CSA C22.1- Canadian Electrical Code.
Label all wires prior to disconnection when servicing
control. Wiring Errors can cause improper and dangerous
operation. Verify proper operation after servicing.
ML39
Page 41