3.2 MECHANICAL TECHNICAL REFERENCES
WARNING: VENT IS NOT CENTERED ON THE UNIT!
Planning the installation
This Mendota Fireplace must be installed and serviced by a qualified installer, service agency, or the gas supplier.
When planning on appliance installation, it is necessary to determine the following information before installing:
•
Where the appliance is to be installed.
•
The vent system configuration to be used.
•
Gas supply piping.
•
Electrical Wiring.
•
Framing and finishing details.
•
Hearth Protection Pad Requirements.
•
Whether accessories such as a ceiling fan are desired.
Selecting Appliance Location
When selecting a location for your appliance, it is important to consider the required clearances to walls.
•
Install appliance on hard metal or wood surfaces extending full width and depth of this fireplace.
•
Do NOT install this fireplace directly on carpeting, vinyl or any combustible material other than wood.
Construct chase to all clearance specifications in manual.
•
Locate and install appliance to all clearance specifications in manual.
85-03-01136
Figure 3-1 FIREPLACE LOCATION
WARNING
FIRE RISK- ODOR RISK
ML39
Page 13