Nstallation - Mendota ML39 Assembly, Installation And Operating Instructions

4.9 LIGHT BULB AND LIGHT LENS INSTALLATION
WARNING: Failure to position the parts in accordance with these diagrams or f ailure to use only part s
specifically approved with this appliance may result in property damage or personal injury.
Before you install a firebox inner, liner kit, or a log set. Install the accent light bulb and the accent light lens kit. To install the light
bulb and light lens kit, follow these instructions:
1. Identify the two light bulb sockets. They are located within the top metal baffle.
Caution: Do not touch the light lens with bare hands. Always use the protective foam wrap supplied with the
light bulb or a pair of clean cloth or neoprene gloves to handle the light bulb. Touching the light bulb will
leave oils and dirt on the lens and will cause premature failure of the light b ulb.
2. Slide base of light bulb inside light bulb holder base after aligning the bulb base shape with the recessed shape
in the bulb holder. Push up all the way.
3. Next, see diagrams, below. Install the light lens base gasket, light lens, light lens retainer bracket and the four
retaining 10-24 nuts.
Warning: Use a 3/8" hex hand driver to tighten nuts.DO NOT over tighten the nuts. Doing so can crack the
light lens.
Figure 4-8 Accent Light Bulb & Lens Installation
85-03-01136
Figure 4-7 Light Housing
ML39 Page 51