O Remove Door; O Replace Door - Mendota ML39 Assembly, Installation And Operating Instructions

4.7 TO REMOVE DOOR
Use the glass latch tool to disconnect the spring latches from the glass frame. Insert tool into hole in latch, pull towards you and
rotate 90-degrees to disengage top latches. Remove tool. There are two spring latches on top of this gas fireplace. Always make
certain the hook glass latches are in the upside-down position after removing the glass frame. This upside-down latch position
will make it easier to reinstall the glass frame later.
With both hands, rotate top edge of glass frame away from unit, approximately 8".
Lift glass frame up 1", at an angle, and move away from unit.
Door is now free from unit.
NOTE: Always check glass gasket condition and gasket seal any time the glass door is remove d and when
reinstalling glass door.
4.8 TO REPLACE DOOR
1. Line up the five bottom tabs on the glass frame with the slots on the bottom of the firebox. Fireplace tabs into slots
and center tabs in slots, left to right.
2. Center glass frame over firebox; left to right.
3. After door has been placed into slots, rotate door towards firebox until gasket seal is
touching the firebox frame.
4. Use the tool provided to connect the spring latches to the glass frame. Fireplace tool into hole in spring latch, pull latch
towards you, rotate latch so the hook is facing downward then release latch to hook to door frame.
Door is now connected and sealed to unit.
85-03-01136 ML39 Page 50