Error Messages In Numerical Order - HP 8753E Programming And Command Reference Manual

Error Messages in Numerical Order

For explanations and suggestions in finding the cause of the error
messages, refer to the alphabetical listing in Chapter 10 of the HP 8753E
Network Analymr User's G&o!& Some error numbers have been omitted
due to obsoleted error messages.
1 OPTIONAL FUNCTION; NOT INSTALLED
INVALID KEY
2
3 CORRECTION CONSTANTS NOT STORED
4 PHASE LOCK CAL FAILED
NO IF FOUND: CHECK R INPUT LEVEL
5
6 POSSIBLE FALSE LOCK
NO PHASE LOCK: CHECK R INPUT LEVEL
7
8 PHASE LOCK LOST
9 LIST TABLE EMPTY
10 CONTINUOUS SWITCHING NOT ALLOWED
SWEEP TIME INCREASED
11
12 SWEEP TIME TOO FAST
13 AVERAGING INVALID ON NON-RATIO MEASURE
FUNCTION NOT VALID
14
NO MARKER DELTA - SPAN NOT SET
15
16 TRANSFORM, GATE NOT ALLOWED
DEMODULATION NOT VALID
17
LIST TABLE EMPTY: occurs if user selects LIST sweep type
19
but there is no list freq. table
20 AIR FLOW RESTRICTED: CHECK FAN FILTER
21 POWER SUPPLY HOT!
POWER SUPPLY SHUT DOWN!
22
PROBE POWER SHUT DOWN!
23
1-48 HP-IB Programrm 'ng and Command Reference Guide
E r r o r