These 7 commands branch an executing sequence to a new sequence if
the following condition is satisfied.
HP-IB Programrm 'ng and Command Reference Guide
Tests the specified input GPIO bit (see
sequence which follows.
Tests the specified input GPIO bit (see
sequence which follows.
Sets the IF' bandwidth. Values: 10, 30,
If loop counter equals zero, then do the
sequence that follows. Range: 1 to 6.
If loop counter does not equal zero, then
do the sequence that follows. Range: 1 to
If limit test fails, then do sequence that
follows. Range: 1 to 6.
If limit test passes, then do sequence that
follows. Range: 1 to 6.
Selects the imaginary display format.
Increments the sequencing loop counter
by 1.
Initializes the internal disk. All previous
information on the disk will be destroyed.
Initializes the external disk. All previous
information on the disk will be destroyed.
Requires pass control when using the
1 -I 19