HP 8753E Programming And Command Reference Manual page 162

The following 5 commands select the standard "type" after the standard
number has been entered during a modify cal kit sequence:
These 5 commands store the indicated file on disk. Used with the INTD
and EXTD commands to designate the internal or external disk.
Arbitrary impedance.
Load.
Open.
Short.
Sets the stimulus stop value. If a list
frequency segment is being edited, sets
the stop of the segment. Range: stimulus
range.
Stores the current instrument state to
disk using the file name provided by the
preceding T I TF 1; command.
Stores the current instrument state to
disk using the file name provided by the
preceding T I TF2; command.
Stores the current instrument state to
disk using the file name provided by the
preceding T I
Stores the current instrument state to
disk using the file name provided by the
preceding T I
Stores the current instrument state to
disk using the file name provided by the
T
preceding I TF5 j command.
Stores the instrument state of the
indicated sequence to disk. Used with the
INTD and EXTD commands to designate
the internal or external disk. Requires
pass control mode when using the HP-IB
1 to 6.
Range:
port.
While editing a list frequency segment,
sets step size. Iikznge: stimulus range
1-155