HP 8753E Programming And Command Reference Manual page 139

Note
The commands for array input and output require the
user to set the data format for transfers in and out of
the instrument. Refer to 'fable l-5 and the mnemonic
descriptions of FORMl, FORMB, FORM3, FORM4, and
Outputs the value of the active function, or the last
active function if the active entry area is OFF.
Outputs the max values for all limit line segments.
Outputs the min values for all limit line segments.
Outputs the smoothing aperture in stimulus units,
rather than as a percentage.
These 12 commands output an error correction array for the active
calibration on the active channel. See 'fable l-8, for the contents of
each array. Each array is output in the currently set form determined
by the FORMn command. The data is in real/imaginary pairs, the same
number of pairs as points in the sweep.
Array 1.
Array 2.
Array 3.
Array 4.
Array 5.
Array 6.
Array 7.
Array 8.
Array 9.
Array 10.
Array 11.
Array 12.
Outputs the currently active calibration
kit, as a less than 1000 byte string. The
data is in FORM 1.