HP 8753E Programming And Command Reference Manual page 137

These 3 commands specify the offset value for the indicated parameter
for a standard being defined during a cal kit modification:
HP-IB Programming and Command Reference Guide
Begins the modify cal kit sequence.
Computes new cal set using adapter
removal.
Begins modifying a sequence. Range: 1 to
6.
Displays the next page of the operating
parameters fist.
No operation. OPC-compatible.
Activates D number of groups of sweeps.
A group is whatever is needed to update
the current parameter once. This function
restarts averaging if ON. OPC-compatible.
Range: 1 to 999.
Sets the number of power meter readings
per point used during a power meter
calibration. Range: 1 to 100.
Offset loads done.
Selects the calibration standard load
as being an offset load, as opposed to
a sliding or fixed load, during a cal kit
modification.
Delay offset. Range: k 1 s.
Loss offset. Range: 0 to 2000 TWs .
Range:
Impedance offset.
Omits the isolation step of a calibration
sequence.
Operation complete. Reports the
completion of the next command received
by setting bit 0 in the event-status
register, or by replying to an interrogation
if OFT? j is issued.
0.1 to 500 CL