HP 8753E Programming And Command Reference Manual page 142

These 3 commands output the limit test results. The results consist of
four fields. First is the stimulus value for the point. Second is an integer
indicating test status. Third is the upper limit at that point. Fourth is
the lower limit at that point. If there are no limits at that point, the
third and fourth fields are zero. The test status is -1 for no test, 0 for
fail, and 1 for pass.
HP-IB Programming and Command Reference Guide
Outputs the learn string, which contains
the entire front panel state, the limit
table, and the list frequency table. It is
always in binary format not intended for
decoding.
Outputs the status of the limit test for
channel 1.
Outputs the status of the limit test for
channel 2.
Outputs the status of the limit test for
channel 3.
Outputs the status of the limit test for
channel 4.
Outputs the limit test results for each
failed point.
Outputs the limit test results for each
point in the sweep. This is an ASCII
transfer.
Outputs the limit test results at the
marker.
Outputs the marker values. The first two
numbers are the marker response values,
and the last is the stimulus value. See
values as a function of display format.
Outputs the memory trace from the active
channel. The data is in real/imaginary
pairs, and can be treated the same as data
read with the OUTPDATA command.
Fast data transfer command for
OUTPMEMO.