HP 8753E Programming And Command Reference Manual page 105

Action Mnemonic
OUTPFORM
OUTPFORF
OUTPICAL< I> 2
lentify OUTPIDEN
ey code
OUTPKEY
earn string OUTPLEAS
imit test:
imit test:
imit test:
imit test:
imit OUTPLIMF
Refer to the "Limit Line and Data Point Special Functions" section in
Values returned for limit test status are: 1 (PASS), 0 (FAIL), - 1 (NO-LIMIT)
S ? Description
OUTPUT (continued)
This command is similar to OUTPLIMF except
1
that it reports the number of failures first,
followed by the stimulus and trace values for
each failed point in the test.
1 Outputs the formatted trace data from the
active channel in current display units. See
1 Fast data transfer command for OUTPFORM.
Only the first number of the OUTPFORM data
pairs is transferred. See 'lhble 1-4.
Outputs the selected interpolated cal coefficienl
See IDN?
Outputs the interpolated power meter cal array
for channel 1 or channel 2.
Outputs the code of the last key pressed, in
1
ASCII format. See Figure l-6 for key codes. - 1
is transmitted for a knob turn.
Outputs the learn string in binary, not intended
1
for decoding.
Outputs status5 of limit test for channel 1.
1
Outputs status.5 of limit test for channel 2.
1
Outputs status3 of limit test for channel 3.
Outputs status5 of limit test for channel 4.
1
Outputs the limit results as described under
1
OUTPLIML for only those stimulus points that
failed.
HP ESASIC