Valid Characters; Units - HP 8753E Programming And Command Reference Manual

Valid Characters

The analyzer accepts the following ASCII characters:
letters
n
numbers
n
decimal points
n
n
semicolons (;)
n
quotation marks (")
n
Both upper- and lower-case letters are acceptable. Carriage returns,
leading zeros, spaces, and unnecessary terminators are ignored, except
for those within a command or appendage. If the analyzer does not
recognize a character as appropriate, it generates a syntax error message
and recovers at the next terminator.

Units

The analyzer can input and output data in basic units such as Hz, dB,
seconds, etc.
S Seconds
V Volts
Input data is assumed to be in basic units (see above) unless one of the
following units is used (upper and lower case are equivalent):
MS Milliseconds
US Microseconds
NS Nanoseconds
P S
HP-IB Programrm 'ng and Command Reference Guide
Hz
Hertz
DB
KHZ Kilohertz
MHZ Megahertz
Gigahertz
FS Femtoseconds