HP 8753E Programming And Command Reference Manual page 157

Selects the point number that the
OUTPDATR command will report.
Range: 0 to the number
Selects the segment number to report
on for the OUTPSEGF and OUTPSEGM
Range: to
1
commands.
Selects sequence. Range: 1
Tells the instrument to wait D seconds
during a sequence. Range: 0.1
Sets the specified bit on the GPIO.
Range: to
0 7.
Sets the date in the following format: DD
MMM YYYY, where DD is the day and
must be 2 digits, MMM is the month and
must be three alpha characters (JAN, FEB,
MAR, APR, MAY, JUN, JUL, AUG, SEP,
OCT, NOV, DEC), and YYYY is the year
and must be 4 digits.
Sets the frequency for low pass transform,
Option 010.
Sets the reference thru.
Sets the reference reflect.
Sets the time in the following format:
HH:MM:SS, where BH is the hour, MM is
minutes, SS is seconds, and each must be 2
digits.
Sets the characteristic impedance of the
measurement system.&nge: 0.1
Displays the desired softkey menu during
a sequence.
Single sweep. OPC-compatible.
Sliding load done.
Specifies the standard as a sliding load
during a standard definition as part of a
cal kit modification, as opposed to a fixed
or offset load.
Sliding load set. OPC-compatible.
of points minus
1.
18.
to
6.
to
3000 s.
to
500 Q.