Table of Contents
Advertisement
PART TWO: Status Request
You can request a status report from your WTU-14 by sending it a
command via e-mail. When the unit receives the command it will
assemble a status report and send it back to the originating e-mail
address. Only inputs that are enabled will be included in the report.
If alarm monitoring is not enabled for a particular input, its status
will be displayed as disabled. To request the status report you need
the unit's password and skyID. The e-mail format to request a status
report is shown below:
To: skyID@mobilemessage.com {replace skyID with your unit's skyID number}
Subject:
Message:
p password gst
A sample e-mail Status Report is shown below:
D1: Pump 1 Run 243:33:12 1591 OK
D2: Pump 2 Run 012:30:00 1295 OK
D3: High Water 000:00:00 0 OK
D4: Door sensor 000:00:00 0 Alarm
D5: Pump 1 fault 000:00:00 0 OK
D6: Pump 2 fault 000:00:00 0 OK
D7: Gen. Run 000:57:49 2 Disabled
D8: Low Fuel 000:00:00 0 OK
A1: Well Level 16 OK
A2: Outside Temp 78 F Disabled
A3: Cabinet Temp 86 F OK
A4: Fuel Level 38 OK
A5: Battery Temp 81 F OK
A6: Flow Rate 33 OK
B: Battery 13.50v OK
P: Power 16.82v OK
O1: Pump 1 On 015:54:44 1573 OK
O2: Pump 2 Off 012:30:00 1295 OK
{replace password with your unit's password}
Chapter 9: Operation
81
Advertisement
Table of Contents
