Table of Contents
Advertisement
Skymetry WTU-14 Manual
Activating your Skymetry WTU-14
Your Skymetry device must be activated on the wireless network
before you can send or receive messages and before any local pro-
gramming is performed for the first time.
To activate your Skymetry WTU-14 device, fill out the activation
form included with the package and follow the instructions, or con-
tact your sales representative with the device serial number.
Your Skymetry WTU-14 is activated when the "In Range" and
"Registered" LEDs are lit.
Note: The Registered LED will blink when the
Skymetry is sending or receiving messages.
Connecting Locally
The Skymetry Software will allow you to connect with the unit to
view status and program it. First, connect a serial cable to a serial
port on your computer. Connect the other end to the 9-pin RS-232
connector on the Skymetry WTU-14. Run the Skymetry Software.
The following screen will appear.
Click the New button to set-up a new WTU-14 unit. The Edit
Skymetry Unit screen will appear (see below).
36
Figure 1: First-Run Unit Information form
Figure 2: Edit Skymetry Unit
Advertisement
Table of Contents
