Internet E-Mail - Phonetics Skymetry WTU-14 User Manual

Enter the name for this destination (up to 12 characters) and in the
Type field select Voice. In the Phone # field enter the area code and
telephone number. A sample alarm telephone call is shown below:
"Hello, Sensaphone Inc. has a message for 'Mike'
<destination name>."
"To accept the message press 1."
"To cancel the message press 2."
{press 1 to hear the alarm message}
"Skymetry alarm at 'Oak Station' <unit name>,
SkyID number '1123350' <skyid>."
"Contact 4, 'High Float' <input name> is in alarm."
To acknowledge send #### <alarm ID>
"To replay message, press the * key."
"To reply to the message, press 2."
"To end this call, press 3."
To acknowledge the alarm you must press "2" (reply to the mes-
sage). Next, enter the four digit alarm ID that was spoken at the end
of the message followed by the "#" key. When prompted to send the
message, enter the "#" key again. The alarm ID is a unique number
that identifies the alarm and the destination. Note that a different
alarm ID number will be sent to each destination—even for the
same alarm.

Internet E-Mail

The WTU-14 can send alarm messages to internet e-mail address-
es. The alarm message will comprise information from within
your Skymetry WTU-14 including the programmed Unit Name,
Destination Name, and Input Name. To program an e-mail destina-
tion, click on the Alarm Notification tab.
Chapter 8: Notification
67