Table of Contents
Advertisement
Skymetry WTU-14 Manual
Overview
When installing and programming a Skymetry WTU-14 there are
several steps required for all installations. Listed below are those
required for a typical installation and start-up of the Skymetry
WTU-14.
1) Confirm wireless coverage for the installation site.
2) Select a wireless messaging plan and activate the unit.
3) Install the unit, set the input jumpers, and wire the sensors.
4) Go online locally and program the unit.
5) Wait for the web page to initialize and become active.
6) Verify status on the web site.
7) Test all sensors and alarm notification—see Chapter 11: Testing
the Skymetry WTU-14
Web Page Initialization
Your Skymetry WTU-14 is accessible via the internet at www.
skymetry.com. From the web page you can view status, make
programming changes, and even control outputs. Before any of
these features can be utilized, the unit must first initialize the web
server. This happens automatically immediately after your first local
programming session with the unit. As soon as you disconnect from
your first programming session the unit will begin to update the
web server with all of its programming. This may take an hour or
two depending on how many parameters were programmed. During
this initialization period it is recommended that the unit remain
powered on and no additional programming changes take place. For
detailed information on the Skymetry web page see Chapter 10.
Data Message Usage
Your Skymetry WTU-14 communicates over the wireless network
using data messages. These are transmitted whenever an alarm mes-
sage is delivered, machine-to-machine command is sent, or a web
update is requested. The number of data messages used for each
type of transmission is shown below in the table:
18
Advertisement
Table of Contents
