Table of Contents
Advertisement
Skymetry WTU-14 Manual
sider placing the unit inside of a cabinet for safety. Use a plastic
or fiberglass cabinet to minimize the signal loss on radio reception.
When installing the unit inside of a metal cabinet, be sure to use an
external antenna as the metal will shield the unit from receiving a
radio signal.
On the top and bottom of the housing are mounting holes to attach
the unit to either a panel or wall. The mounting surface should be
sturdy enough to support 2 lbs.
The unit should be mounted using four #10-32 bolts where appro-
priate, or four #10 tapping screws. (The screw kit for the Skymetry
WTU-14 includes (4) #10-32 screws, (4) #10-32 nuts, and (4) #10
lockwashers). When mounting the unit to a wall, make sure the
mounting screws fully engage a solid member (for example, a stud)
of the support structure. Mount the Skymetry WTU-14 in an upright
position so that you can easily connect wires to the terminal strips.
The dimensions of the enclosure are: 8.0" x 6.1" x 1.6". See Figure 1.
22
Advertisement
Table of Contents
