Table of Contents
Advertisement
Skymetry WTU-14 Manual
Next, click on the Pump Control link. This will bring up the pump
mode setup screen. Next, select the type of pump control you want
to do:
If you select one of the Analog modes, you will have to fill in the
Lead, Lag, and Pumps-Off fields. In Dry Contact Float mode these
fields are disabled. Enter the appropriate values and click OK or
Apply.
Next, click on the output to use for Pump Control. Click the drop-
down box and scroll to the bottom to select Pump Control. Click
OK or Apply. This will activate the Pump Control logic. Make sure
all input devices and equipment are operational and ready for use.
56
Figure 2: Output properties showing pump control
= Drain Analog Level
= Drain Dry Contact Floats
= Fill
Analog Level
= Fill
Dry Contact Floats
Figure 3: Pump Mode—Analog programming
Advertisement
Table of Contents
