Skymetry WTU-14 Manual
Setting the Output Name
To set up the relay outputs, click on the Outputs tab. Next, click on
the Name for Output 1 (blue) to bring up the Output 1 Properties
screen. Enter a name for the output which describes the device that
the output will be controlling.
Configuring the Output Operating Mode
Click the drop-down arrow and select the operating mode for the
output. You can have the relay automatically turn on for a variety of
alarm conditions, either individual alarms or if any alarm occurs.
If you will be controlling the output manually or via a machine-to-
machine command, select Manual mode. If you will be using the
output for fill or drain pump control, select Pump Control. For sim-
plex pump control set only one output to Pump Control mode; for
duplex pump control set both outputs to Pump Control mode. See
Chapter 6 for more information on pump control programming.
50
Figure 2: Output Properties screen
Figure 3: Output Operating mode