Table of Contents
Advertisement
Skymetry WTU-14 Manual
Skymetry WTU-14 Web Page
You can view status and change settings in your Skymetry WTU-14
via the internet. This makes it possible to manage your unit from
anywhere in the world. See Chapter 10 for detailed information on
using the web page.
How it works
When the Skymetry WTU-14 is installed you should perform all
programming via the local serial port. You must set the password.
After you disconnect from the unit, the WTU-14 will begin to ini-
tialize the status and programming information on the Skymetry.
com web page. This may take one to two hours depending on the
number of programming parameters changed and the response time
of the wireless network. Take care not to make additional program-
ming changes until the web initialization has finished. To view
status or make programming changes via the web page, go to www.
skymetry.com and enter your SkyID and Password.
Note that the unit keeps track of programming items that have
changed so that each time the Programming Refresh Link is clicked,
only the changed items are sent. To get just the current status, you
should click the Status Refresh Link. This will retrieve the latest
input status from your unit. It will take a few minutes for this pro-
cess to execute.
Note: Each time you click the Status or
Programming Refresh links, data will be sent to and
from your WTU-14 unit. This will use data mes-
sages. Once you exceed your data message limit,
additional charges will apply.
38
Advertisement
Table of Contents
