Protection Against Overheating; Storage; Trouble-Shooting - Silvercrest SLE 450 A1 Operating Instructions Manual

__CPE111670_B6.book Seite 12 Mittwoch, 11. März 2015 12:51 12
11. Protection against
overheating
The device has an overheating protection
system.
• The overheating protection system will
switch the device off automatically if
there is a risk of overheating.
• It is then impossible to switch the device
on again for 3 minutes.
• After approx. 3 minutes, the device
starts automatically.
• Check whether external conditions
could have triggered the overheating
protection system, e.g. temperature
above 35|°C or a closed flap valve 1
over the air outlet.

12. Storage

DANGER for children!
~ Keep the device out of the
reach of children.
• Always store the device in an upright
position.
• Select a location where neither frost,
high temperatures nor moisture can af-
fect the device.
12 GB

13. Trouble-shooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~ Do not attempt to repair the device your-
self under any circumstances.
Fault Possible causes/Action
• Has the device been
connected to the power
supply?
• Check the water level in
the water tank 5.
• Check the position of
the water tank.
• The overheating protec-
No function
tion system has
switched the device off.
Wait for approx. 3 min-
utes.
• The device was
switched off shortly be-
forehand. Wait for a
few minutes.
• Are the filters 29, 30
dirty?
• Is the air inlet 8 blocked?
The dehumid- • The temperature is low.
ification • Is the device operating
does not in AIR CLEAN mode?
seem to be No dehumidification
working very takes place with this
well. program.
• Is a window open, or
has steam been generat-
ed in the room?
Excessive • Is the device standing on
noise a level, solid surface?