Timer; Child Safety Lock; Hose Drainage - Silvercrest SLE 450 A1 Operating Instructions Manual

__CPE111670_B6.book Seite 10 Mittwoch, 11. März 2015 12:51 12

7.5 Timer

• The timer can be combined with all
4|modes.
• There are 24 switch-off times that can
be selected, from 1 to 24 hours.
• After the expiry of the time that has
been set, the device is shut down and
the timer function is terminated.
1. During operation, press the TIMER 21
button. The TIMER LED 14 will flash.
2. Use the arrow keys 20 to select a switch-
off time of between 1 to 24|hours. The se-
lected time flashes in the display|15 for
5|seconds and is then saved.
• If you want to end the timer earlier than
the set time, press TIMER 21 twice or
switch the device off by pressing
STAND-BY 18.

7.6 Child safety lock

• You can switch on the child safety lock
during operation.
• If the child safety lock is switched on,
the device cannot be operated using the
buttons.
1. To activate the child safety lock, hold
down the button MODE 19 for approx.
5 seconds until LC appears on the dis-
play|15. The buttons are locked.
2. To deactivate the child safety lock, hold
down the button MODE 19 again for
approx. 5 seconds until LC disappears
from the display 15. The device can now
be operated again by using the buttons.
10 GB

8. Hose drainage

In the case of very damp rooms it often
makes more sense to discharge the water di-
rectly through a hose, instead of collecting it
in the water tank. Check the connection sys-
tem regularly for tightness.
• For the hose drainage you can either
use the supplied hose 24 or connect a
garden hose.
WARNING! During hose drainage, the de-
vice runs in continuous mode. This means
that the water collected must be able to
drain reliably, otherwise puddles will form
on the floor.
1. Figure B/C: unscrew the fastener 23
on the rear.
2. Remove the plug 22.
3. Figure B: Supplied hose 24: place
the supplied hose on the opening.
Figure C: Garden hose: screw the
garden hose adapter 25 onto the open-
ing. Pay special attention to the correct fit
of the sealing ring. Now screw the gar-
den hose onto the adapter.
WARNING! Only hand-tighten the adapt-
er. Do not use any wrenches, as this could
damage the adapter.
NOTE: depending on the garden hose sys-
tem used, a further adapter could be re-
quired. This can be purchased at specialist
retailers.
4. Place the device in a position where the
end of the hose is over a drain. The open
end of the hose should lie below the outlet
of the device. (The hose should be in-
clined.)
5. Switch the device on as described above
and select a mode.